LOT OF N ° 10 VERTICAL STORAGE TANKS ON 600 HL LEGS BOTTOMED BASE AND CONICAL ROOF. Outside diameter: 3000 mm
Height of the cylindrical part: 8150 mm
H legs: 900 mm
Total tank H: 9600 mm (approximately)
roof: conical
Bottom: conical

Finishes:
Tank interior: 2B
Outer tank: Fioretto
These finishes are guaranteed with adhesive plastic film protection before the start of
any processing.

The weldings are performed with automatic and manual procedure T.I.G. with inert gas protection (Argon) on both sides of the joint, with full penetration, pickled and washed with natural external beads. Grinding and polishing of natural internal heels. Flattening of the plating welds by cold rolling. Structure suitable to withstand a capacity of 600 hl with a density of 1.1 kg / dm3. Design in compliance with V.S.R.
COMPONENTS
- N ° 6 pyramidal support feet made from folded sheet metal equipped with adjustable feet with thread and plate for resting on the floor.
- lifting eyebolts applied on the roof.
- Ladder rests
- Decentralized top cover Ø 400 with flag opening complete with double-acting mechanical relief valve. Filling channel from the manhole cover to the roof ridge ..
- Elliptical door with swivel arm inside / outside
- useful light 340x440 mm.
- Total discharge with DN80 ball valve.
- Total discharge with DN80 ball valve.
- N ° 2 heat exchange pockets 13.5 square meters applied to the plating mechanically made by cavity through spot welding with protection of argon gas complete with inlet / outlet fittings of the carrier fluid.
- Well for temperature probe. - Tap takes samples with ball valve.
- Level group with stainless steel needle valve, polycarbonate tube ø 20, steel protection.
- Thermometer with analog.
TEMPERATURE CONTROL SHIRT
MATERIALS: AISI 304 cold rolled stainless steel with 2B flowered finish.
CONFIGURATION: Overlaying of a suitably rusticated sheet or other system fixed with T.I.G. in order to create more passage channels for the heating or cooling fluid, increasing the turbulent motion to increase the heat exchange coefficient, all at low levels of pressure drop.
- Max working pressure with liquid: 2.5 bar
- Hydraulic test pressure: 5 bar
- Operating temperature: -20 ° / + 110 ° C
- Circuit capacity: 6 l / m2
- Pressure drop: 0.033 bar / m at 3200l / h
- Entry-exit spouts: 1 "/ 1/4
- threaded well for temperature probe: N ° 1
DIMENSIONING OF POCKETS FOR ENERGY SAVING: The surface of the pockets must be suitable to keep fermenting red musts at 25-28 ° C, white at 14 ÷ 16 ° C with water inlet temperature 5 ° C and cooling time from max 30 ° C (must input) at 18 ° C in max 24 h (consider fermentation).

The price is for each.